The Ford Barn - View Single Post

MikeK · 11-09-2013, 01:06 AM

Keep in mind the engine centerline is NOT horizontally parallel with the frame. In an "A" the engine sits on the motor mounts with the rear end & tranny down 3 degrees. Now add in all the factors Tom mentioned. Because of this the universal joint between the rear of the trans and the torque tube has almost no angular difference when the car is sitting on the ground with the stock spring heights.

11-09-2013, 01:06 AM	#3
MikeK Senior Member Join Date: May 2010 Location: Windy City Posts: 2,919	Re: Drive Shaft Angle Question Keep in mind the engine centerline is NOT horizontally parallel with the frame. In an "A" the engine sits on the motor mounts with the rear end & tranny down 3 degrees. Now add in all the factors Tom mentioned. Because of this the universal joint between the rear of the trans and the torque tube has almost no angular difference when the car is sitting on the ground with the stock spring heights.