View Single Post
Old 03-28-2011, 09:04 PM   #7
Charles Reese
Senior Member
 
Charles Reese's Avatar
 
Join Date: May 2010
Location: Richmond, VA
Posts: 882
Default Re: Gear Shifter Boot (early)

this is the LH brake lever boot - metal ring is molded inside the rubber for stability ... not sure why just the ring is being reproduced

my question is about the presence (or lack of) of a 'boot' at the base of the shifter assembly as it passes through the floorboard. i cant find anyone reproducing the early floor mat (and no carpet on open model) so am concerned about dust/wind coming through the floorboard
Attached Images
File Type: jpg DSC01503.jpg (71.1 KB, 29 views)
File Type: jpg DSC01504.jpg (58.9 KB, 26 views)
File Type: jpg DSC01505.jpg (55.2 KB, 23 views)
File Type: jpg DSC01506.jpg (76.1 KB, 24 views)

Last edited by Charles Reese; 03-30-2011 at 04:05 PM.
Charles Reese is offline   Reply With Quote