The Ford Barn - View Single Post

Uncle Bob · 10-30-2015, 08:57 AM

Sponsored Links (Register now to hide all advertisements)

'32-4 spindles are much the same, here's a thread from the HAMB that lays out how it's done; http://www.jalopyjournal.com/forum/t...thread.970252/
Dennis and his dad have been doing this kind of swap for years and produce/sell all the pieces to do what he shows.

Sorry, just realized you asked mechanical backing plates, don't think it's been done for the above reasons.

10-30-2015, 08:57 AM	#3
Uncle Bob Senior Member Join Date: May 2010 Location: Salado, TX. Posts: 733	Re: Drum interchange Sponsored Links (Register now to hide all advertisements) '32-4 spindles are much the same, here's a thread from the HAMB that lays out how it's done; http://www.jalopyjournal.com/forum/t...thread.970252/ Dennis and his dad have been doing this kind of swap for years and produce/sell all the pieces to do what he shows. Sorry, just realized you asked mechanical backing plates, don't think it's been done for the above reasons. __________________ Luck occurs when preparation and opportunity converge.