Quote:
Originally Posted by Rowdy
I am in the proccess of building a test stand for Model A engines. I am using the Gleaner combine mount as mentioned before. I was under the impression that these had the proper rake in them, but prior to welding things up I discovered that the deck of the bare block is dead level. I do not have a manifold here at the house, besides the one on the delivery which I do not want to remove at this time. Does anyone have any measurements or degree that would help? Thanks Rod
|
3 degrees, although I have measured a winfield aftermarket manifold at 2 3/4 degrees. That should get you into the ball park