The Ford Barn - View Single Post

Old Henry · 04-05-2014, 08:15 PM

Thanks Pete. I will print your suggestions (and all others) and take them to discuss with the machinist on Monday. I did not check the run out before I took the flywheel off. I will see if I can find a source for the instrument to check it when I get it all back together as you suggested. If you can provide any more information about that instrument and a source for it that would help. I've never checked run outs of anything but think I'm just beginning to understand what that means.

Thanks again for your knowledge, advice, and time you took to give it.

04-05-2014, 08:15 PM	#10
Old Henry Senior Member Join Date: Oct 2010 Location: Orem, Utah Posts: 5,762	Re: Can this 59A fly wheel be saved? Thanks Pete. I will print your suggestions (and all others) and take them to discuss with the machinist on Monday. I did not check the run out before I took the flywheel off. I will see if I can find a source for the instrument to check it when I get it all back together as you suggested. If you can provide any more information about that instrument and a source for it that would help. I've never checked run outs of anything but think I'm just beginning to understand what that means. Thanks again for your knowledge, advice, and time you took to give it. __________________ Prof. Henry (The Roaming Gnome) "It is good to have an end to journey toward; but it is the journey that matters, in the end.” Ursula K. Le Guin in The Left Hand of Darkness Last edited by Old Henry; 04-05-2014 at 08:28 PM.*