Quote:
Originally Posted by columbiA
I dont know why guys torque the lug nuts to 100#,just tighten them good & tight by using the socket on the hand crank.The length of offset on the crank will keep the lug nuts from being over tightened. Lateral end play of 1/16"or less is nothing to worry about on axle shaft.Even more end play likely wouldnt hurt anything.
|
I think he was talking about the AXLE NUT !!!!
I am with Brent...
( Differential carrier wear and worn spider gears that are allowing the axle to move in and out )
I just helped a buddy with a 34 rear that go all bagged out. His axle mover in and out about 3/16 the carrier was junk
It now has .006 of in and out play