View Single Post
Old 06-14-2011, 11:12 PM   #15
John Kennedy
Senior Member
 
John Kennedy's Avatar
 
Join Date: May 2010
Location: Tucson Arizona
Posts: 301
Default Re: The Flathead oil modification thread...

Well HELL. Minor setback. I cleaned out all my metal shavings from the passageway mods, and broke thru the casting at the bottom of the vertical. Right above where the 45degree bend is.

I'm guessing sleeve it? It's drilled to 9/16 dia. Hole goes into clutch area. Where can I find a suitable sleeve? Brass or steel?
__________________
Building a 29 Sedan on 32 chassis........ very slowly....
John Kennedy is offline   Reply With Quote