[crotex]

I have replaced the points, condensor, plate, wires from every point, coil, and the wire from the coil to the distributor. I have chacked all of the parts suchs as the dist. cap, wires, coil, and switch with a test light and all check out. The points are set at 0.20 and I just can not get any fire to the plugs. I have pulled the plugs cleaned them up, cleaned the connections on the rotor, all of the sparking points inside the cap, and worked on the timing. The last thing I tried was taking the wire that goes to the dist. and hooking it straight to the negative side on the coil and then running a wire from the positive side of the coil to the post on the starter. Still no spark. I have clecked the wire inside the distributor and looks to be good and tests out ok. Anything else that anyone has posted or suggested on here I am not sure of. I either don't understand or don't know how. I am new to this stuff and don't know very much. Some things I am not familiar with.