View Single Post
Old 05-01-2012, 11:08 PM   #13
Jim Parker Toronto
Senior Member
 
Jim Parker Toronto's Avatar
 
Join Date: May 2010
Location: Toronto, Ontario, Canada
Posts: 1,289
Default Re: Dixi Brake Drum Lathe questions

"For the rear hub of the A try some of the flanged ones in pic (83378)with the wheel bearing in, and one of the small tapered cones for the outside ---the smaller spindle size is the same as the Barrett I think, the larger 1" is the same as Barrett, and Ammco."
Kurt is correct on these, very similar to what I use. For the front, I use two ball ended pieces that are double sided and slotted to fit tight.
I will try and post some pictures tomorrow if I can find some time. Jim
Jim Parker Toronto is offline   Reply With Quote