[George Miller]

Originally Posted by forever4

Here is a link to some ideas on locating the bar.
The kwik-way uses the bearing bolt holes.

http://www.fordgarage.com/pages/boringbarfixtures.htm

The K-W bar and block fixture shown can be used with my Lempco to finish semi-finished main caps only, perhaps like what Bill Barlow may do?

Use the K-W fixtures to locate the bar to the block section while in the Lempco frame. They are both 1.25 dia.

http://www.fordgarage.com/pages/lempcoboring.htm

Thanks for the info. I have a home made boring bar. I use the camshaft bore and pan rail on the front. Ford machined bore for oil slinger seal on the rear. It has always been right on. But I might look into the info from you.