Re: Need help from the flathead gurus...? Valve clearance issue
Assuming that you are taking the reading when the cam is in it's correct position. A 'sticky' valve guide could cause this. When it is at it's widest gap, tap down on the valve to see if the gap changes. If not then it's most likely a problem below the valve such as in the lifter or cam area.
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES
Last edited by 51 MERC-CT; 09-18-2016 at 05:41 AM.
|