Quote:
Originally Posted by jimTN
I have found the Model A type hub "knocker" type nut a very good tool for pulling hubs. Just remove the original nut, screw the knocker nut on, jack up the far side and tap the nut with a 8lb sledge. Have not had a hub that would not come off yet and have not damaged any axles. Those nuts are available from most of the peddlers.
|
that sounds like a bad idea, just think about what your doing. i would spend $150 for the winfield puller then all the money and time to rebuild my rear end. why do you think Henry put that grove in the rear hub, for the puller