The Ford Barn - View Single Post - How to finish top folding mechanism on 35 Convertible

Henryat1140 · 04-21-2013, 04:50 PM

The metal top frame itself would be chrome plated.

Yes there is a wooden strip around the inside of the body where the top and pads are tacked into.

There is a wooden header bow in the front connecting the top to the windshield, and an additional wooden bow to establish the high point of the top.

The 35-36 Book from the early V8 Ford club is a great source of information.

Good luck

Henry

04-21-2013, 04:50 PM	#2
Henryat1140 Senior Member Join Date: May 2010 Location: Hereford, Maryland Posts: 218	Re: How to finish top folding mechanism on 35 Convertible The metal top frame itself would be chrome plated. Yes there is a wooden strip around the inside of the body where the top and pads are tacked into. There is a wooden header bow in the front connecting the top to the windshield, and an additional wooden bow to establish the high point of the top. The 35-36 Book from the early V8 Ford club is a great source of information. Good luck Henry