Quote:
Originally Posted by Gasoline
Thanks! I will remove the MSD coil. It was actually MSD electronic service that told me that if it is 9 volts on the positive side on the coil I´m good, but if it is less , I would remove the resistor.
Here are the results from todays test during idle:
MSD Blaster 2 (0.7 ohms) with resistor= 6 voltage on coil positive.
MSD Blaster 2 without resistor= 7 voltage on coil positive.
Accel 8140 super stock (1.5 ohm) with resistor= 8 voltage on coil positive.
Accel 8140 super stock without resistor= 9 voltage on coil positive.
So you are saying stick with the Accel 1.5 ohms and the resistor 0.8-1.5 ohms?
|
Yep, but even more important , did it get hot ???
That was the issue right?