The Ford Barn - View Single Post

V12Bill · 11-10-2011, 10:07 PM

I am installing the exhaust on my 39 Pickup and am at the rear outlet of the muffler. It appears that bracket 91A 5274 is nothing more than a piece of bar stock cut to length and bolted to the outer frame and X member frame. The Green Bible doesn't show any drawings nor does the 38, 39 Authenticity manual show pictures. I have a photo that I took from the Barn that some one had submitted and it shows this bar but not a good angle. On the frame are two holes on either side of the outer rail and X frame. Does the bar need 4 bolts to hold in place or just two? What is the thickness of the bar and what are the length and width? Is the hole for the exhaust bracket in the center of the bar or offset in or out? Sorry to get so wordy, as it is only a piece of bar stock. Would appreciate any response.

11-10-2011, 10:07 PM	#1
V12Bill Senior Member Join Date: May 2010 Location: Mt. Holly,NJ Posts: 1,822	Exhaust Bracket I am installing the exhaust on my 39 Pickup and am at the rear outlet of the muffler. It appears that bracket 91A 5274 is nothing more than a piece of bar stock cut to length and bolted to the outer frame and X member frame. The Green Bible doesn't show any drawings nor does the 38, 39 Authenticity manual show pictures. I have a photo that I took from the Barn that some one had submitted and it shows this bar but not a good angle. On the frame are two holes on either side of the outer rail and X frame. Does the bar need 4 bolts to hold in place or just two? What is the thickness of the bar and what are the length and width? Is the hole for the exhaust bracket in the center of the bar or offset in or out? Sorry to get so wordy, as it is only a piece of bar stock. Would appreciate any response.