[37ford4dr]

this started out as the Bitching universal hotrod set and i customized to fit more like a stock set up. i did significant work on the trans tunnel since that was for a TH350. let me see if i can find some pictures of the square tubing subframe. the subframe basically follows the trans tunnel and goes to out to the outside frame under the top of the floor board and i think i put one more middle strut from the trans tunnel leg to the outside frame right in the middle so there was no movement in the floor board. and the subframe was made to not obstruct any of the brake rods clutch rods etc....you can see the sheet metal screws holding he trans tunnel down and then the larger threaded botls with washers holding the larger floor boards down. the subframe basically goes from bolt to bolt with with more leg in the middle