View Single Post
Old 06-13-2010, 07:29 PM   #11
Brendan
Senior Member
 
Brendan's Avatar
 
Join Date: May 2010
Location: At my kitchen table in Santa Rosa, Ca
Posts: 2,902
Default Re: Replacing axle seals 39 ford

Quote:
Originally Posted by jimTN View Post
I have found the Model A type hub "knocker" type nut a very good tool for pulling hubs. Just remove the original nut, screw the knocker nut on, jack up the far side and tap the nut with a 8lb sledge. Have not had a hub that would not come off yet and have not damaged any axles. Those nuts are available from most of the peddlers.
that sounds like a bad idea, just think about what your doing. i would spend $150 for the winfield puller then all the money and time to rebuild my rear end. why do you think Henry put that grove in the rear hub, for the puller
Brendan is offline   Reply With Quote