View Single Post
Old 07-25-2012, 04:17 PM   #18
fgray
Junior Member
 
Join Date: Jul 2012
Location: Custer, SD
Posts: 15
Default Re: Steering stabilizer

Did some checking and found a few questionable things. The right spindle arm where it goes into the spindle was loose. The radius rod appears to be secure, but the toe in is 1 and 1/16 inches, a bit much I think as the book says 1/16 to 1/32". The left wheel bearing was a bit loose, and the wheels appear to be out of balance. No one in Custer will try to balance them, so I spit into the wind and balanced them on the spindle not too good I'm afraid will get it to town soon and get a pro to do it. Haven't set the toe yet will tomorrow and then see where we are.Fred
fgray is offline   Reply With Quote