Quote:
Originally Posted by 41panelmark
Tried a different condenser, this one reads .3 mfd. Difficult to find one that reads 3.5. I have a pile of them and all but 2 read about .26 which I understand is not enough. The 2 odd ones, one reads .4 and the other reads .45 which may be too much.
I installed a 1.5 ohm resister in front of the internally resisted Bosh Blue (which reads about 3.0 ohms resistance). These 2 combined helped bring my voltage to the coil down but it may not be enough.
I am running a 12 volt neg ground system after the coil I am seeing 8 volts is that still too many amps at the points?
|
Sounds like way to much resistance. You should not need a ballast resistor with a 3.0 ohm coil, something isn't right here. Any idea what the system voltage is at higher rpms?