04-13-2012, 08:47 PM
|
#14
|
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: Zenith carb rebuild
Quote:
Originally Posted by cuda
Couldn't it be sufficient to just check the hole sizes with ends of the drill bits? If the next bigger size won't fit and the next smaller size does, wouldn't that make it close enough?
|
YUP! Chief, my dad and Guru of Model A stuff, rebuilt carbs down in the woods of Oklahoma, NO electricity, I worked a tire pump with a pointy pipe in the hose while Chief blew out the passages & jets. He cleaned the carbs with Lye soap & water in a cast iron pot hanging on a hook in the fireplace. He "built" Model A's to sell, so we could EAT. He was associated with Buddy Boggs, the county's un-authorized Model A Heaven, and Bill Ogan, the hometown Authorized Ford Dealer. I've got a "million" Model A stories, if I could remember them all! Bill W.
__________________
"THE ASSISTANT GURU OF STUFF"
Last edited by BILL WILLIAMSON; 04-13-2012 at 09:05 PM.
Reason: Fun Stuff
|
|
|