The Ford Barn - View Single Post - King Pin not matting with brake shaft housing

Lincolnville · 01-21-2023, 06:59 PM

Right now, there is no gap on the driver side. The perches are new, and they are properly seated in the front axle. I tried switching the king pins and the gap grows to a 1/4" or so on both sides.
I will purchase new king pins and see what happens.
Thanks for your comments.

01-21-2023, 06:59 PM	#4
Lincolnville Senior Member Join Date: Jul 2014 Location: Chicago, IL Posts: 130	Re: King Pin not matting with brake shaft housing – 1932 Ford Right now, there is no gap on the driver side. The perches are new, and they are properly seated in the front axle. I tried switching the king pins and the gap grows to a 1/4" or so on both sides. I will purchase new king pins and see what happens. Thanks for your comments.