I hope some one on here might have a suggestion where I should look next. The car up till now has always run well. I just changed the rubber boots from looms to outside caps with new ones and while at it there were no gaskets between the outer and inner caps so did that too. I cleaned the holes really well with fine paper in a drill as well as the tips on the plug wires and made sure they were pushed all the way in the cap but now have both front cylinders on right front missing. I changed plugs and there was no difference on those two cyls. even though there is spark but a little weak I think. Shorting the others with a screw driver you notice the difference easy. Where should I go next ? If this were a rotor issue it would affect all of them wouldn't it ?
Thanks guys, Bob