View Single Post
Old 02-17-2013, 05:33 PM   #9
Wilbur
Senior Member
 
Wilbur's Avatar
 
Join Date: Nov 2012
Location: Mays Landing, NJ
Posts: 113
Default Re: Bad Condenser Symptoms?

Hey, lookie here, just set the coil wire near some steel and let it go, Jack! Anyhow, the timing check went fine. She is spot-on. This new, modern distributor, from Snyder's, has about 200 miles on it and has run fine up to now.

My old one just needed a new point block, but l decided to get a new one because the bushings were pretty sloppy on the shaft.
Wilbur is offline   Reply With Quote