View Single Post
Old 03-19-2011, 09:56 AM   #20
kp
Senior Member
 
kp's Avatar
 
Join Date: May 2010
Location: Wimberley ,Tx.
Posts: 232
Default Re: Not getting fire!! Won't start. PLEASE HELP FAST!!

run a jumper wire across the Ing. switch,you have to remove the switch from the dash to do this but like Tom states above, the switch may have lost contact inside.I had this problem and took the switch apart and made correction, or if the contacts on the amp meter are grounding out it will not fire either. You could have a bad wire ,test light them for continuity .
kp is offline   Reply With Quote