Re: Simple to make and use Toe-In gauge
The measurement is between 1/16"-1/32" difference from back to front. I always think about a bent rim which will throw the measurement off. So, here is how I do it:
Drill a whole in a block of wood to tightly fit and hold a sharpie pen
Jack up one front wheel at a time just off of the floor
Place the sharpie in the block on the floor and the point of the sharpie to a flat spot close to the center of the tire
Turn the tire one revolution slowly with the sharpie against the tire creating a centerline
Take your measurements from the centerlines
This method will compensate for any runout from your rims
I have used this method several times with great success
|