The Ford Barn - View Single Post

Bassman/NZ · 06-13-2010, 05:16 PM

The seals inside the axle half do NOT need a special tool to install. Get a flat washer with an outside diameter slightly smaller than the o/d of the seal, and weld it to a length of pipe about 1/2" in from one end. Hold the new seal on the tool with a dab of grease and bang it in. Make sure the lip of the seal faces back towards the banjo.

06-13-2010, 05:16 PM	#7
Bassman/NZ Senior Member Join Date: May 2010 Location: Napier, New Zealand Posts: 2,001	Re: Replacing axle seals 39 ford The seals inside the axle half do NOT need a special tool to install. Get a flat washer with an outside diameter slightly smaller than the o/d of the seal, and weld it to a length of pipe about 1/2" in from one end. Hold the new seal on the tool with a dab of grease and bang it in. Make sure the lip of the seal faces back towards the banjo.