The Ford Barn - View Single Post

Larry Jenkins · 05-17-2015, 07:34 PM

Upside down on top of the bottom boss on the spindle? Hope this makes sense.

I am reassembling the front axle on the bench, not the car. My plan is to ensure the clearance between the top bearing and the axle is between 0.008 and 0.010 with the cross bolt in and tightened. Will probably have to do this a couple times.

Larry

05-17-2015, 07:34 PM	#7
Larry Jenkins BANNED Join Date: Feb 2015 Location: East Central Iowa Posts: 1,275	Re: Don't laugh too hard.. Upside down on top of the bottom boss on the spindle? Hope this makes sense. I am reassembling the front axle on the bench, not the car. My plan is to ensure the clearance between the top bearing and the axle is between 0.008 and 0.010 with the cross bolt in and tightened. Will probably have to do this a couple times. Larry