View Single Post
Old 04-04-2012, 05:15 PM   #7
Buford
Senior Member
 
Buford's Avatar
 
Join Date: May 2010
Location: La Luz, NM. 88337
Posts: 1,050
Default Re: Help with a Fordomatic transmission

Thanks for all the input, I think I have found the trouble. I called Gene at Flatomatic trans in Oregon...He is an old hand with these Ford transmissions. He said it was a common problem on the small case Fordomatic to slip in reverse and low after the trans case got cracked for any number of reasons. I did the oil pressure tests and it is all normal. Gene indicated that the trans was dumping fluid in the rear servo supply down stream of the test port and there isn't any other test ports to isolate the problems. He said there is most likely a crack in the center support. Now I will need to find a small case air cooled Transmission case to put all my new guts in.
Can't beat older guys when it comes to practical knowledge!

Any of you good Ford guys have transmission case for me?

Again, thanks for all the help on this site...
Buford is offline   Reply With Quote