The Ford Barn - View Single Post

supergnat · 08-05-2012, 05:02 PM

I suggest you purchase the puller below which matchey your hub style (CHECK THE DIAGRAM IN THE CATALOG) . I had a stubborn one ant this tool did the trickjfor me. I took the info below from the Bratton's catalog. Good luck.
Supergnat

REAR WHEEL HUB PULLER

For Year(s): 28-31

Opening at base of puller hooks into the ring on the hub. One inch bolt at end of puller must be tighten down aginst axle end to loosen hub from axle. Made from strong ductile iron. A copy of an early after market puller.

Part #06150 REAR WHEEL HUB PULLER $ 31.00 REAR WHEEL HUB PULLER

For Year(s): 28-31

Opening at base of puller hooks into the groove on the hub. One inch bolt at end of puller must be tighten down aginst axle end to loosen hub from axle. Made from strong ductile iron. A copy of an early after market puller.

Part #06160 REAR WHEEL HUB PULLER $ 31.00

08-05-2012, 05:02 PM	#12
supergnat Senior Member Join Date: Jan 2011 Location: Palmyra, NJ Posts: 475	Re: Removing rear brake drum I suggest you purchase the puller below which matchey your hub style (CHECK THE DIAGRAM IN THE CATALOG) . I had a stubborn one ant this tool did the trickjfor me. I took the info below from the Bratton's catalog. Good luck. Supergnat REAR WHEEL HUB PULLERFor Year(s): 28-31 Opening at base of puller hooks into the ring on the hub. One inch bolt at end of puller must be tighten down aginst axle end to loosen hub from axle. Made from strong ductile iron. A copy of an early after market puller. Part #06150 REAR WHEEL HUB PULLER $ 31.00 REAR WHEEL HUB PULLERFor Year(s): 28-31 Opening at base of puller hooks into the groove on the hub. One inch bolt at end of puller must be tighten down aginst axle end to loosen hub from axle. Made from strong ductile iron. A copy of an early after market puller. Part #06160 REAR WHEEL HUB PULLER $ 31.00