[Old Henry]

Originally Posted by Ronnie

I assume you used a 1/4" drive socket on it.
The zirc threads should be 1/4 x 28 tpi looking at the pic. Did you try the removal on or off the car.
If it comes out here is one option.
http://www.saeproducts.com/taper-thr...-fittings.html

R

1/4" socket would not fit. 9/32" was a bit big. Clamped vice grips on it and it would not turn - just rounded the thing. This was all on the work bench.

If I can find a street L that will replace the elbow that's on there I, hopefully, can screw in an extended zerk fitting that I've found.