The Ford Barn - View Single Post

OLD...BILL · 02-13-2011, 02:18 PM

HEY 47: Where are the numbers, and are they stamped or cast, is the main shaft machined between lobs or with cast markings?? The lobes, how tall and thick at the base ( not wide ) The top of the lobe, is smooth round roll over, or is it peaked,with very little flat at top ??... Pictures, lots of pictures .
And a WARM WELCOME to the newbee. (rookie).... OLD....BILL

02-13-2011, 02:18 PM	#3
OLD...BILL Senior Member Join Date: May 2010 Location: Northern California,coast Posts: 552	Re: cam id HEY 47: Where are the numbers, and are they stamped or cast, is the main shaft machined between lobs or with cast markings?? The lobes, how tall and thick at the base ( not wide ) The top of the lobe, is smooth round roll over, or is it peaked,with very little flat at top ??... Pictures, lots of pictures . And a WARM WELCOME to the newbee. (rookie).... OLD....BILL