The Ford Barn - View Single Post - machining backing plates for Juice brakes

peewee2you · 07-17-2013, 01:10 AM

This is an article on the HAMB in regard to various Ford years and the change over to Hydralic brakes. There is reference on the #2 msg of the thread and reference's Model A's and juice brakes. The members name on the Hamb is Modernbeat, thread is titled BRAKES, The Brake Article to end all Brake Articles , article in thread titled:
ABOUT BRAKES
By Denny Art
From Rod Action circa 1975

http://www.jalopyjournal.com/forum/s...late+machining

07-17-2013, 01:10 AM	#13
peewee2you Senior Member Join Date: May 2010 Location: Elk Grove, CA Posts: 663	Re: machining backing plates for Juice brakes This is an article on the HAMB in regard to various Ford years and the change over to Hydralic brakes. There is reference on the #2 msg of the thread and reference's Model A's and juice brakes. The members name on the Hamb is Modernbeat, thread is titled BRAKES, The Brake Article to end all Brake Articles , article in thread titled: ABOUT BRAKES By Denny Art From Rod Action circa 1975 http://www.jalopyjournal.com/forum/s...late+machining