Thread: machining backing plates for Juice brakes
View Single Post
Old 07-16-2013, 07:49 PM   #12
Brendan
Senior Member
 
Brendan's Avatar
 
Join Date: May 2010
Location: At my kitchen table in Santa Rosa, Ca
Posts: 2,903
Default Re: machining backing plates for Juice brakes
Quote:
Originally Posted by Brendan View Post
some one posted a good link to the HAMB about this and its gone can you please repost the link... thanks ...Brendan

anyone remember the post on the hamb?
__________________
If it would have been a snake it would have bit ya!

i can't spell my way out of a paper bag!
Brendan is offline   Reply With Quote