Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by russcc
Did a search on the forum here and found a set of thread chasers for reasonable money. In all my years with cars and as a machinist, I only needed one once for a spark plug hole, and that was MM. So I only need a 7/16-14. I know I can make one, but would prefer to buy it. Any sources a for single thread chaser tap. Have done an internet search and all the comes is regular taps. Thank you Fordbarners
|
I use them a lot, all different sizes, SAE & Metric. They are very handy to have. If you always work with new stuff, guess you might not need them, but clean/chase all of the bolt holes on any of the blocks I work on.