The Ford Barn - View Single Post

Kevin in NJ · 09-11-2011, 08:39 PM

Did you put a counter sink edge on the holes of the sheet metal?

Been a while so someone correct me. I am pretty sure the sheet metal was countersunk with a drill. That is what is being recalled in my brain from the almost perfect rust free 28-29 trunk lid I owned at one time.

09-11-2011, 08:39 PM	#7
Kevin in NJ Senior Member Join Date: May 2010 Location: South East NJ Posts: 3,398	Re: Correct Screws for Rumble Lid Latch Did you put a counter sink edge on the holes of the sheet metal? Been a while so someone correct me. I am pretty sure the sheet metal was countersunk with a drill. That is what is being recalled in my brain from the almost perfect rust free 28-29 trunk lid I owned at one time.