Thread
:
Correct Screws for Rumble Lid Latch
View Single Post
09-11-2011, 07:15 PM
#
4
Kevin in NJ
Senior Member
Join Date: May 2010
Location: South East NJ
Posts: 3,398
Re: Correct Screws for Rumble Lid Latch
Counter sunk screws.
You will notice the D nut is not flush at the top of the plate to allow clearance for the taper.
Also check out my rumble lid page:
Rumble lids
Kevin in NJ
View Public Profile
Send a private message to Kevin in NJ
Visit Kevin in NJ's homepage!
Find More Posts by Kevin in NJ