View Single Post
Old 06-16-2011, 01:40 PM   #35
Bruce Lancaster
Member Emeritus
 
Join Date: May 2010
Location: Madison, NJ
Posts: 5,230
Default Re: The Flathead oil modification thread...

The plug is a clever adaptation. Note that the block shown is Canadian, with extra hole supplied by factory, which is why no drilling was required. Also, this restricts your plumbing (if done with no machining) to what will go through the 1/4" pipe fittings, which scares me...but is what Ford did with success during WWII.
Bruce Lancaster is offline   Reply With Quote