The Ford Barn - View Single Post

TD · 04-19-2012, 10:09 PM

I'm installing a new set of teflon cups, springs, and end caps on my drag link and rod. Is there a rule of thumb how tight to make them, or a typical depth to stop screwing down the cap?
TD

04-19-2012, 10:09 PM	#1
TD Senior Member Join Date: Jul 2011 Location: shelby, nc Posts: 201	drag link advise I'm installing a new set of teflon cups, springs, and end caps on my drag link and rod. Is there a rule of thumb how tight to make them, or a typical depth to stop screwing down the cap? TD