Quote:
Originally Posted by iJoemac
Thanks to jrelliot I now have the necessary information at hand and shall submit photos of the installation after it is done. Now that I see how the reinforcing bracket actually mounts it makes sense to me and I have ordered a pair. As is usually the case it is a very simple and straight forward once you "see the light".
|
Oooops, mucho later I see I said I would post pictures. I did, but over on the HAMB. If anyone is stuck and needs pictures check over there.... If need be I can re-post them here.
The grommets should be a snug fit on the shaft and a snug fit in the cowl. Do not cut the grommets. The shaft actually mounts to the inner reinforcing bracket and the cowl grommet offers some secondary support only.