The Ford Barn - View Single Post

mpalilonis · 12-29-2012, 08:50 AM

Thanks... I did it right then, only have two thin washers on the Main Jet. I bought the rebuild kit from Macs for this carb, all the jets matched the heights of the ones I took out. So I felt comfortable putting it back together. The Cap Jet sits slightly off center, at 10 o'clock. Also, the kit came with two different Compensator Jets... One had a much smaller hole than the other. There is no numbers stamped on it, so which one should I use?

12-29-2012, 08:50 AM	#3
mpalilonis Member Join Date: Dec 2010 Location: Philadelphia, Pa Posts: 62	Re: Zenith Carb Rebuild Question Thanks... I did it right then, only have two thin washers on the Main Jet. I bought the rebuild kit from Macs for this carb, all the jets matched the heights of the ones I took out. So I felt comfortable putting it back together. The Cap Jet sits slightly off center, at 10 o'clock. Also, the kit came with two different Compensator Jets... One had a much smaller hole than the other. There is no numbers stamped on it, so which one should I use?