The Ford Barn - View Single Post

jrelliott · 07-04-2012, 12:14 PM

Years ago an article in Restorer magazine had the plans for stands that fit on an engine stand that would work on '28 to '31 fenders. Built up the stands and used them to repair and get prepared for painting. Used angle iron and were curved to fit the curvature of the frame for the front fenders. They worked great as could rotate the fenders and work from both sides. Left them with the Lady Slipper A club in MN so cannot provide pictures.

07-04-2012, 12:14 PM	#3
jrelliott Senior Member Join Date: May 2010 Location: Pine, AZ Posts: 797	Re: Fender Paint Stands Years ago an article in Restorer magazine had the plans for stands that fit on an engine stand that would work on '28 to '31 fenders. Built up the stands and used them to repair and get prepared for painting. Used angle iron and were curved to fit the curvature of the frame for the front fenders. They worked great as could rotate the fenders and work from both sides. Left them with the Lady Slipper A club in MN so cannot provide pictures.