Quote:
Originally Posted by ModelAArmy
I understand now but I watched a Shinn video and he was adjusting them on a work bench. He was not using this tool.
|
Paul's clutch adjusting method does not use the tool, but instead uses a caliper. That method sets the fingers to be exactly the same but with the clutch having no pre-load tension on the springs by not being bolted in and against the clutch disk.
I have always used the tool and had the clutch bolted to the flywheel.
One important aspect of both methods is that the finger adjustment needs to be exactly the same for all fingers.
It kind of makes sense that the two methods should give the same results, but I have not tested that so I cannot say.