Quote:
Originally Posted by svm99
I ream the perch and spring with a 3/4” reamer to be sure the hole is to size and also measure the cartridge with a micrometer. About .001” interference fit is all that will press in the perch in my experience. I machined a cupped tool to press on the body of the shackle cartridge. The spring is much easier to do than the perch.
Good luck.
|
Pins were specified to be .003" - .0035" oversize.
With the proper tool, they press in very easily. I did a set about three weeks ago. Took only minutes each.