Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by Bruce of MN
I cut up some all thread to make three studs to press in the pinion assembly using the torque tube.
[/IMG]
|
Glad that worked out for you. I was thinking of doing the same using three studs also and pulling them down evenly.
Quote:
Originally Posted by Synchro909
When you put the rear section of torque tube on, make sure it is oriented correctly. The bolts at the front of it are not uniformly spaced. Get it wrong and you'll have to take it off again and do it again - the right way this time, hopefully!
|
Thanks for both tips.