[frank long island]

rev the stuff you get at the home center is not the greatest see if you can find aircraft brand stripper or rock miracle brand I used these when I worked in a body shop they work best if the temp is 50-60 degrees but wear gloves as they will burn the hell out of your skin. as for your bleed through put a couple of layers of tape also when finished wipe the panel with lacquer thinner to remove any residue also where door jambs and door seems use the tape trick leaving 1/4 inch from edge as you will be sanding the panel you can remove that little area it is a lot of dirty work no matter what way you do it the only other way I would do it is find a media blaster in your area but that will be costly $500-$1000 is what it would cost in NY. area and then use duct tape to protect the red along with cardboard wait until you have to do bodywork and sand for paint then the dust starts. also you could set a fan blowing out to lighten the load in the garage keep up the good work and enjoy