Quote:
Originally Posted by 29racer
Hi there. I am having trouble sourcing info regarding the rear oil seal fitting on the Scat model B crankshaft. Apparently it is machined to use a small block Chevy seal but I cannot get any info from Scat. I know Bob Bouldin did a kit for the model A for this seal, but does anybody know if there is one available for the B?
I am in London England so I am somewhat at a disadvantage when trying to source parts and people with the necessary knowledge.
Any information would be appreciated. Thank you in advance.
Regards Simon
|
Dan McEachern makes a Chevy Small Block seal adapter for the "B" engine. I have attached an ad from him...
His contact info should be on the pasted ad.
I have used the seal you are describing several times.
The seal adapters you need are shown at the bottom of the picture...the picture quality is not very good...they are very faint.
Good Day.