Forum: Early V8 (1932-53)
06-30-2013, 07:50 PM
|
Replies: 8
Views: 1,455
|
Forum: Early V8 (1932-53)
06-30-2013, 07:46 PM
|
Replies: 8
Views: 1,455
|
Forum: Early V8 (1932-53)
06-30-2013, 07:29 PM
|
Replies: 8
Views: 1,455
|
Forum: Early V8 (1932-53)
06-30-2013, 05:34 PM
|
Replies: 8
Views: 1,455
Help! Brakes pull to left
Need help fast- I rebuilt the brake cylinder on the right rear of my roadster and now it literally dives to the left when braking hard. The brakes are Locheed post war 42-48 brakes with only the top...
|
Forum: Early V8 (1932-53)
06-18-2013, 08:49 AM
|
Replies: 2
Views: 1,327
1934 Roadster brakes
I replaced the brake cylinder on the left rear and now it pulls to the left hard when braking. I have adjusted all the brakes but to no avail. Can a rear brake shoe cause it to pull left and if so,...
|
Forum: Early V8 (1932-53)
06-17-2013, 08:50 PM
|
Replies: 3
Views: 1,448
1934 Ford Roadster Pulls to the left
I replaced the brake cylinder on the left rear and now it pulls to the left hard when braking. I have adjusted all the brakes but to no avail. Can a rear brake shoe cause it to pull left and if so,...
|
Forum: Early V8 (1932-53)
04-11-2013, 06:49 PM
|
Replies: 6
Views: 1,681
Rear leaf spring in square hole of the frame
Does any one have a suggestion on how to get the square head of the center bolt in the rear spring to go through the square hole in the cross member. I
have used chalk lines to align the centers of...
|
Forum: Early V8 (1932-53)
04-09-2013, 05:05 PM
|
Replies: 1
Views: 1,187
1934 Ford univeral joint lubrication
I realize this is a dumb question but how does the universal joint get it's lubrication at the front of the torque tube on my 34 roadster. I am putting it back together after rebuilding the rear end....
|
Forum: Early V8 (1932-53)
04-06-2013, 08:50 AM
|
Replies: 13
Views: 5,195
|
Forum: Early V8 (1932-53)
04-05-2013, 06:33 PM
|
Replies: 13
Views: 5,195
putting the leaf spring back together
I just finished rebuilding the differential on my 34 roadster and need to reassemble the rear :confused: leaf spring.I could sure use some advice an how to do this without injuring myself.The spring...
|
Forum: Early V8 (1932-53)
03-28-2013, 06:12 PM
|
Replies: 4
Views: 1,616
torque tube hook up
I am getting ready to hook up the torque tube on my 34 roadster. I have a new driveshaft roller bearing and the speedometer drive gear snap ring that secures it. Should I install the bearing before...
|
Forum: Early V8 (1932-53)
03-24-2013, 08:40 AM
|
Replies: 22
Views: 8,665
|
Forum: Early V8 (1932-53)
03-22-2013, 11:20 AM
|
Replies: 22
Views: 8,665
clutch chatter in reverse
my 34 roadster has a lot of clutch chatter when backing up- but not going forward. Does this ring a bell with:confused: anyone?
|
Forum: Early V8 (1932-53)
03-21-2013, 10:14 AM
|
Replies: 3
Views: 1,328
|
Forum: Early V8 (1932-53)
03-20-2013, 10:24 AM
|
Replies: 3
Views: 1,328
differential disassembly
I just finished dropping the rear end out of my 34 roadster and removing the wheel hubs. The rear end locked up because there was no oil in the differential. I want to take it apart to find out what...
|
Forum: Early V8 (1932-53)
03-09-2013, 10:44 AM
|
Replies: 13
Views: 6,377
|
Forum: Early V8 (1932-53)
03-06-2013, 08:31 PM
|
Replies: 13
Views: 6,377
|
Forum: Early V8 (1932-53)
02-07-2013, 09:24 AM
|
Replies: 13
Views: 6,377
|
Forum: Early V8 (1932-53)
02-06-2013, 06:30 PM
|
Replies: 13
Views: 6,377
|
Forum: Early V8 (1932-53)
02-05-2013, 11:22 AM
|
Replies: 4
Views: 1,900
removing and repairing 1934 Ford rear end
I have a 1934 ford roadster that locked up in the rear end due to no oil in the differential. I would like to tackle this job myself but need some expert advice on how to go about pulling the rear...
|
Forum: Early V8 (1932-53)
12-13-2011, 01:25 PM
|
Replies: 1
Views: 1,391
Changing carburator jets
:)Can anyone tell me if the Jets on a 4 barrel carburator can be changed without removing the carburator from the manifold? It is a Holly 98 GR 7809. Thank you.
|
Forum: Early V8 (1932-53)
09-07-2011, 12:11 PM
|
Replies: 20
Views: 16,624
Installing a steering stabilizer
I just purchased a SO CAL steering stabilizer for my 1934 Ford roadster that has a death wobble at low speeds. The directions to install the stabilizer refers to the lower radius rod or lower four...
|
Forum: Early V8 (1932-53)
08-20-2011, 10:03 AM
|
Replies: 5
Views: 1,576
34 Ford Roadster front end shaking
My 1934 Ford roadster has a violent front end shaking from side to side when driving slowly and crossing a bump when turning. I have had it checked out at an alignment shop and they addressed all of...
|