Forum: Model A (1928-31)
11-20-2022, 07:27 PM
|
Replies: 10
Views: 7,771
|
Forum: Model A (1928-31)
04-05-2018, 06:42 PM
|
Replies: 58
Views: 11,047
Re: Unfixable random cutting out
From a post of mine a few years ago:
Check the copper strap that runs on the outside of the flat spring on the points (it is kind of U shaped). I had this same problem, the strap is too long on...
|
Forum: Model A (1928-31)
03-14-2018, 05:59 PM
|
Replies: 24
Views: 7,103
Re: Sound deadening and Insulation Materials
I used the foil faced (2 sides) with plastic bubble stuff that is sold by Menards with the 3M #90 adhesive they sell, worked good to quiet the car up and provides insulation. Made a big difference...
|
Forum: Model A (1928-31)
02-25-2018, 09:27 PM
|
Replies: 76
Views: 13,812
|
Forum: Model A (1928-31)
02-11-2018, 05:15 PM
|
Replies: 53
Views: 12,182
|
Forum: Model A (1928-31)
01-03-2018, 08:24 PM
|
Replies: 32
Views: 10,821
Re: Zenith carburetor paint
Glad I have a couple of cans left.
This stuff may work, it is supposed to be fuel proof for models.
http://www.klasskote.com/re-model-crafting-epoxy-paint
|
Forum: Model A (1928-31)
12-27-2017, 09:22 PM
|
Replies: 21
Views: 4,405
Re: New battery
I installed an OPTIMA battery with the hold down sold by Synders. Works great.
|
Forum: Model A (1928-31)
12-13-2017, 08:01 PM
|
Replies: 19
Views: 2,496
Re: Convert Original Generator to 12V
A good old type automotive electric shop can change the winding's to properly charge a 12 volt battery. Yes you can just put a 12 volt cut out on, however it will not charge the battery very fast,...
|
Forum: Model A (1928-31)
08-24-2017, 07:34 PM
|
Replies: 29
Views: 5,187
Re: Help needed with cb install.
As others stated this is a voltage up converter that uses a common ground, it is designed to convert 6 volt positive ground systems to 12 volt negative ground. Using a common ground, these use a...
|
Forum: Model A (1928-31)
08-23-2017, 09:17 PM
|
Replies: 29
Views: 5,187
Re: Help needed with cb install.
The RED INPUT wire goes to the negative terminal on your battery, or to for example the wire that feeds your dome light. The black wire goes to the chassis of your car. On the CB side, the red wire...
|
Forum: Model A (1928-31)
06-18-2017, 07:06 PM
|
Replies: 14
Views: 3,009
Re: Broken Carburetor Jet
I know this sounds like it will break the casting, however it does not...
Heat the casting around the jet to a DULL red with an oxy acetylene torch, preferably using a rose bud tip. Then using a...
|
Forum: Model A (1928-31)
06-10-2017, 09:26 PM
|
Replies: 44
Views: 7,301
Re: Engine Serial Numbers as VIN
Maybe try reading the Federal law about this, and read all of it, there are exceptions that allow the re-marking.
18 U.S. Code § 511
|
Forum: Model A (1928-31)
06-01-2017, 08:55 PM
|
Replies: 11
Views: 2,011
|
Forum: Model A (1928-31)
05-08-2017, 06:01 PM
|
Replies: 16
Views: 2,108
Re: Motor turns VERY slow
A #2 copper wire attached to the bottom starter bolt (clean the paint off from the starter under the bolt so you get good contact) to the same location that the battery cable connects to the frame is...
|
Forum: Model A (1928-31)
07-10-2016, 08:02 PM
|
Replies: 7
Views: 1,939
Re: turn signals
Better to hook to the frame ground point,where the ground strap from the battery connects. You never want a path through other electronics to the battery that is better than the path that the...
|
Forum: Model A (1928-31)
06-01-2016, 09:46 PM
|
Replies: 8
Views: 2,175
Re: Respirator opinions.
As long as what you are using matches what the respirator will filter out is what you want. You really need to be fit tested for this type of respirator to be truly safe. As an Advance Rescue...
|
Forum: Model A (1928-31)
04-27-2016, 05:07 PM
|
Replies: 30
Views: 6,290
|
Forum: Model A (1928-31)
09-15-2015, 07:50 AM
|
Replies: 6
Views: 1,933
Re: Transmission Oil
I have used it for sometime in my A's transmission, works great. Remember there are more ideas about what type and brand of lube to use than there is A's to put it in. It is your car do what works...
|
Forum: Model A (1928-31)
08-30-2015, 08:48 AM
|
Replies: 13
Views: 9,887
|
Forum: Model A (1928-31)
07-17-2015, 10:03 PM
|
Replies: 19
Views: 3,722
Re: New battery didn't help
I have posted this before. Use a good meter, hook one lead to the post of the battery that has the ground strap attached. Noe hook the other side to the grounded side of the points. Run the...
|
Forum: Model A (1928-31)
06-30-2015, 07:36 PM
|
Replies: 26
Views: 6,304
Re: Coil
This is the one I use for a 6 volt system, it is resin filed and will not leak.
Pertronix 40111 - Pertronix Flame-Thrower Coil
I bought mine from Amazon as they had the best price at the time.
...
|
Forum: Model A (1928-31)
06-30-2015, 05:42 AM
|
Replies: 21
Views: 4,494
Re: Seems strange, battery vs spark at the plug
Also check and clean all of the ground paths, and the supply side to the coil. Actually just clean all your electrical connections. A dirty connection or loose wire can have these type of issues.
|
Forum: Model A (1928-31)
06-28-2015, 10:53 AM
|
Replies: 38
Views: 5,823
Re: Resistor Mystery
The resistors go from the "powered", flashing / pulsing side of the bulb circuit to ground, normal LED lights do not draw enough current to operate a standard flasher properly. If the flash rate is...
|
Forum: Model A (1928-31)
06-22-2015, 08:06 PM
|
Replies: 26
Views: 7,686
|
Forum: Model A (1928-31)
06-21-2015, 10:35 PM
|
Replies: 26
Views: 7,686
|