Forum: Early V8 (1932-53)
Today, 12:05 PM
|
Replies: 16
Views: 870
|
Forum: Early V8 (1932-53)
Yesterday, 01:52 PM
|
Replies: 25
Views: 793
|
Forum: Early V8 (1932-53)
04-29-2024, 06:02 PM
|
Replies: 87
Views: 4,709
|
Forum: Early V8 (1932-53)
04-28-2024, 05:50 AM
|
Replies: 25
Views: 793
|
Forum: Early V8 (1932-53)
04-26-2024, 11:36 AM
|
Replies: 28
Views: 3,031
|
Forum: Early V8 (1932-53)
04-25-2024, 04:29 PM
|
Replies: 16
Views: 870
|
Forum: Early V8 (1932-53)
04-25-2024, 04:20 PM
|
Replies: 13
Views: 637
|
Forum: Early V8 (1932-53)
04-25-2024, 07:33 AM
|
Replies: 51
Views: 3,979
|
Forum: Early V8 (1932-53)
04-25-2024, 07:29 AM
|
Replies: 16
Views: 870
|
Forum: Early V8 (1932-53)
04-24-2024, 05:13 AM
|
Replies: 17
Views: 1,170
|
Forum: Early V8 (1932-53)
04-23-2024, 12:48 PM
|
Replies: 17
Views: 1,170
Re: Brake drum question
On earlier hubs and drums the drum fits over the hub. On later assemblies the drum fits on the inside of the hub. The drums are different. I think the early ones have the smaller ones and the later...
|
Forum: Early V8 (1932-53)
04-23-2024, 12:42 PM
|
Replies: 87
Views: 4,709
|
Forum: Early V8 (1932-53)
04-21-2024, 03:33 PM
|
Replies: 87
Views: 4,709
|
Forum: Early V8 (1932-53)
04-20-2024, 05:06 AM
|
Replies: 141
Views: 10,005
|
Forum: Early V8 (1932-53)
04-19-2024, 11:17 AM
|
Replies: 28
Views: 3,031
|
Forum: Early V8 (1932-53)
04-18-2024, 01:09 PM
|
Replies: 20
Views: 1,416
Re: Flat head back firing pop. pop over and over
As the vehicle is new to you and unknown it is very difficult to say what the problem might be. A full description of the truck and further info on when the problem occurs would also help. is it bad...
|
Forum: Early V8 (1932-53)
04-17-2024, 10:42 AM
|
Replies: 7
Views: 965
Re: Seen on Facebook
That's a pretty accurate representation of 90% of the videos I watch on youtube.
|
Forum: Early V8 (1932-53)
04-16-2024, 04:45 AM
|
Replies: 50
Views: 1,933
|
Forum: Early V8 (1932-53)
04-15-2024, 02:37 AM
|
Replies: 6
Views: 518
Re: Frame vin
Sometimes useful to hold a light at a very low angle to cast a shadow across the digits. Also use the camera in your phone to video the area from all angles and use macro mode. Then watch it on a...
|
Forum: Early V8 (1932-53)
04-13-2024, 01:31 PM
|
Replies: 87
Views: 4,709
|
Forum: Early V8 (1932-53)
04-12-2024, 10:37 AM
|
Replies: 28
Views: 3,031
|
Forum: Early V8 (1932-53)
04-11-2024, 07:14 AM
|
Replies: 7
Views: 598
Re: 6V vs 12V condenser
Sometimes the rotor arm gets weak on the helmet distributors and allows the spark to short to the shaft the rotor sits on. A new rotor might help or pit some heat shrink on the shaft. This, like many...
|
Forum: Early V8 (1932-53)
04-08-2024, 03:09 AM
|
Replies: 96
Views: 6,451
Re: Break-in gone wrong!
Is there any chance the block could have been modified at some point in the past for 90% full flow external filter? If so the horizontal passageway in the oil gallery might have a grub screw in it.
...
|
Forum: Early V8 (1932-53)
04-05-2024, 10:34 AM
|
Replies: 28
Views: 3,031
|
Forum: Early V8 (1932-53)
04-03-2024, 08:59 AM
|
Replies: 20
Views: 1,006
Re: Tiny ends heavy axles
Hi Hank. The ends are small because the axles were "stretch" dropped. I am not keen on that effect either.
|