Forum: Model A (1928-31)
04-28-2013, 02:14 PM
|
|
Replies: 2
Views: 1,014
|
|
Forum: Model A (1928-31)
04-28-2013, 01:52 PM
|
|
Replies: 2
Views: 1,014
Door Seals
Does anyone know of a source for an illustration showing the proper installation of door seals on a closed cab vehicle. My Tudor seems be be lacking seals and channels, and I can't seem to find any...
|
|
Forum: Model A (1928-31)
04-24-2013, 05:44 PM
|
|
Replies: 26
Views: 6,475
Re: trailering model A
8X20 enclosed works for me (29 P/U or 29 Tudor); I can squeeze in and out just fine. You probably don't need the extra length, but it my case, that's where I keep my wife on long trips. :D
Before...
|
|
Forum: Model A (1928-31)
04-24-2013, 05:15 PM
|
|
Replies: 0
Views: 1,010
No Trunk Will Travel?
Sorry for the (perhaps) misleading title.
My question is: Where were the jack, jack handle, tools, etc stored in a 29 Tudor when the car was not equipped with a trunk? :confused:
|
|
Forum: Model A (1928-31)
04-22-2013, 02:09 PM
|
|
Replies: 2
Views: 1,940
Hub cap question
The hub caps on a recently purchased Tudor seems to be lacking as to the way they are secured to the wheels. It seems someone has simply bent the ears on the hub cap (spread them open) and then...
|
|
Forum: Model A (1928-31)
04-17-2013, 01:08 PM
|
|
Replies: 5
Views: 1,602
|
|
Forum: Model A (1928-31)
04-17-2013, 12:55 PM
|
|
Replies: 9
Views: 2,530
Re: Carb Adjust Question
Tom, I have a 2 tooth box. I'll look at what you suggest, but I guess if worse comes to worse, I'll have to sacrifice a fully opening throttle for a proper idle speed.
Thanks
|
|
Forum: Model A (1928-31)
04-13-2013, 02:41 PM
|
|
Replies: 9
Views: 2,530
Carb Adjust Question
I was not happy with the top speed of a recently purchased Tudor, so I started going over the engine hoping to find something obvious. In doing so I discovered that the throttle linkage (between the...
|
|
Forum: Model A (1928-31)
04-13-2013, 01:44 PM
|
|
Replies: 11
Views: 2,384
|
|
Forum: Model-A
04-04-2013, 04:31 PM
|
|
Replies: 0
Views: 804
Jack wanted
Jack for 29 Tudor wanted. Working condition. Send PM please.
|
|
Forum: Model A (1928-31)
03-30-2013, 03:39 PM
|
|
Replies: 4
Views: 1,471
Re: Looking for a running sedan
Buy one that's already done, though not necessarily 100% original. A sharp driver. Its cheaper, and you will still find plenty to do on it. Expect to pay $10-16,000, if you shop smart.
|
|
Forum: Model A (1928-31)
03-30-2013, 03:28 PM
|
|
Replies: 6
Views: 1,149
Re: Steering Gear Assembly Question
If you have a grease fitting on the box, how do you fill same without blowing seals? I guess I should pull the fitting and try to see what's in the box now; 600w oil or grease.
|
|
Forum: Model A (1928-31)
03-30-2013, 03:26 PM
|
|
Replies: 8
Views: 1,747
Re: this is not good
I'm going through the same issue with my 29 P/U. Did you blow any water out of the tail pipe when you started up? That's a sure sign of water getting into a cylinder.
Pressure from a running...
|
|
Forum: Model A (1928-31)
03-30-2013, 03:08 PM
|
|
Replies: 6
Views: 1,149
Steering Gear Assembly Question
I have been doing some front-end work on a 29 Tudoor I recently purchased, and in the course of doing, I realized that the fill plug on my 2 Tooth assembly has been replaced with a grease fitting. ...
|
|
Forum: Model A (1928-31)
03-30-2013, 02:58 PM
|
|
Replies: 4
Views: 1,477
Auction Find
Just purchased two Model A engines at a local auction. One is a short block; the other is complete including water pump, distributor, carb, gen, starter, bell housing, clutch and trans. Total price:...
|
|
Forum: Model A (1928-31)
03-30-2013, 02:49 PM
|
|
Replies: 82
Views: 24,112
Re: non- detergent oil
Tractor Supply has a non-detergent in several weights including 40, which is what I am using.
|
|
Forum: Model A (1928-31)
09-22-2012, 03:00 PM
|
|
Replies: 3
Views: 1,283
Water in Oil and Tailpipe
The last time I started my 29 pick-up a large amount of water blew out of the tailpipe. Fearing the worst, I checked the oil. Yup, it was milky.
Drained the oil today and the first quart to come...
|
|
Forum: Model A (1928-31)
04-06-2012, 09:21 AM
|
|
Replies: 10
Views: 2,804
Re: Alignment Camber Problem
Thank you all.
If I am looking for a replacement axle, what shall I look for? Are all axles (except AA) the same? Are they stamped for identification?
|
|
Forum: Model A (1928-31)
04-04-2012, 05:51 PM
|
|
Replies: 5
Views: 1,524
Newbe Questions
1) My 29 Pick-up has a windshield that opens from the bottom (hinged at the top). Unfortunately, there is no mechanism to hold the windshield in the open position. Photos I have seen suggest that...
|
|
Forum: Model A (1928-31)
04-04-2012, 05:41 PM
|
|
Replies: 10
Views: 2,804
Alignment Camber Problem
Newbe here. Recently purchased a 29 Pick-up and the RF wheel is clearly miss-aligned. Looking from the front, the top of the wheel is leaning to the outside of the vehicle and tire wear is much...
|
|
Forum: Model A (1928-31)
02-22-2012, 06:39 PM
|
|
Replies: 6
Views: 2,870
Pick-Up Bed Sideboards
I would like to add sideboards to my 29 and I hoped that some of you with more experience might have some photos and/or suggestions.
Thanks........
|
|
Forum: Model A (1928-31)
02-19-2012, 06:36 PM
|
|
Replies: 22
Views: 4,776
Re: Antifreeze? Or something else?
Thanks guys, I appreciate all of the help. I'll give my Moto-Meter a test in the kitchen and see if it will show any kind of temperature rise. I'll also look for coolant (or water) just below the...
|
|
Forum: Model A (1928-31)
02-19-2012, 11:59 AM
|
|
Replies: 22
Views: 4,776
Re: Antifreeze? Or something else?
Hi Guys,
I am a newbe to Model A's, having just purchased a 29 pick-up. Radiator maintenance is one of my many questions, so I guess this thread is a good start. Here goes:
1) I live in...
|
